

First, let's figure out which usbmon bus our relevant device is communicating on. If this winds up being too much, you can filter down to a specific USB bus, or device. Attach a new USB device- you should see USB packets being to fill the view! Once you've selected all of the interfaces, click on the blue "start" fin to begin capture. We don't necessarily know where our device will wind up connected, so for now, we'll select all of them: Each USB interface begins with usbmon and ends with a number:Įach interface corresponds to a different USB bus on your computer. Once Wireshark has started, you'll be asked to select the interfaces you want to listen on. To run wireshark, run the following command: wireshark While it's not as full-featured as other USB analyzers, it has the significant benefit of being free. The easiet wasy to view USBMon output is with Wireshark, a common suite used for protocol analysis. Accordingly, we'll need to load the module before we can use it: sudo modprobe usbmon USBMon performs its monitoring from inside of a Linux kernel module, which has full access to all USB packets processed by the system. As a software-only solution, usbmon is an excellent zero-cost starting point. In this training course, we'll use the Linux usbmon analyzer to capture traffic between your host computer and a target USB Device. These analyzers are limited, and require control over the target- but they're low cost and convenient. Software analyzers can be used on most operating systems.Use of USBProxy will be covered in the training course. USBProxy-Nouveau provides a simple ability to analyze the USB data being proxied.A USB protocol analyzer is an expensive piece of equipment, but is the most flexible way of capturing USB communications.There are several methods to inspect USB communciations as they occur: When working with USB devices, it's often helpful to have insight into the data that's being exchanged between the host and the device. Monitoring USB Communications with USBMon
